Special note: The EJ timer can not be used with compact fluorescent style bulbs. Release the buttons and wait for to start blinking. CAL will appear in the top left corner. Year will be flashing between the word year and DATE will be flashing. If daylight savings is not being used press the button again and select manual.
|Published (Last):||17 April 2017|
|PDF File Size:||9.98 Mb|
|ePub File Size:||2.17 Mb|
|Price:||Free* [*Free Regsitration Required]|
Bulb is missing, loose, disconnected or burned out. MAN ual mode. Timer switches at incorrect times or skips some switching times. There are conflicting Astronomic and Specific When using a combination of Astronomic switching time settings.
See the next column if you wish to identify and remove conflicting settings. The timer does not "catch up" to the pro- grammed load state. The timer will then begin following the schedule. Load only operates when the remote 3-way switch is in one position or timer ignores the Remote switch is wired incorrectly.
Excessive length of wire greater than feet or Timer ignores remote 3-way switch even buried wiring to the remote switch. Remote switch is defective or worn out. Batteries not seated in holder, holder misaligned, Battery holder is difficult to snap in place. This warranty is extended to the original household purchaser only and is not transferable.
This warranty service is available by either a returning the product to the dealer from whom the unit was purchased, or b mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. Make sure fuse is good or circuit breaker is on. Press MODE to select the desired operating mode. Make sure time of day and at least one scheduled activity are programmed. Complete the steps under "Setting the Calen- dar.
Recheck wiring, especially for the jumper, per "2—Install the Switch Timer". Eliminate condition by replacing the buried cable or doing without the remote switch. Consult fac- tory for other options. Otherwise try the above remedies. Seat the batteries, then install the holder with the notch facing down.
Intermatic EJ500C Supplementary Manual
Intermatic EJ500 Installation And User Instructions
Intermatic EJ500C Programming Manual